DIP TESTER Model DS-02

Usage

The Dip Tester enables you to set up and maintain the flow soldering equipment easily and accurately. This has been developed with using the latest technology and expertise in soldering equipmet.

Feature

●Wide range of data can be obtained at one operation.・Preheat temperature
(temperature on underside of the board caused by preheaters.) ・Soldering temperature ・Dip time
●A liquid crystal is used for the digital display to prolong battery life.
●Memory of data is retained until the power is turned off.
●The attachment unit of the tester can be adjusted accordingly to correspond to various circuit board widths.
●By attaining high density equipment of electronic circuits, more compact configuration and lighter weight of the
case are adopted.

product specification

Item	Specification
Model Name	DS-02
Standard contact point compensation	Automatic compensation with platinum temperature measuring resistor
Ambient temperature	5 minutes or less OK at ambient 120C
Battery to use	S-006P 9VDC, 1 piece
Usable time	More than 10 continuous hours
Life of sensor mounting plate	More than 5,000 times at soldering temperature 250C and dip time 5 sec.
Outer Dimension	95(W) x 200(D) x 65(H) (mm) (Main unit)
Width of Installation	132mm - 162mm
Weight	800g (without battery)

* The above specifications are subject to change without notice.